Menu
Shopping Cart
Service Center
Home
/
Servicing Instructions
/
VSI
/
Replacement of Joystick
Service Center
VSI - Replacement of Joystick
Disassemble the VSI and identify the Joystick type, as described in [
Disassembly and identification of Joystick type
]
Remove the Joystick as described in [
Replacement of Joystick Gaiter
]
Fit the replacement Joystick, ensuring the notch on the Joystick is correctly positioned.
Calibrate the Joystick with the following steps.
With the Joystick Cable disconnected, switch on the VSI. This will enter a Calibration Mode, which will be indicated by the left-hand speed LED flashing as below.
Connect the Joystick Cable and carefully hold the two halves of the VSI together as if re-assembling.
Press the Horn Button. The left-hand two speed LEDs will now flash as below.
Deflect and hold the Joystick in the
full-forwards
position and then depress the Horn Button until there is a bleep, then release. The left-hand three speed LEDs will now flash as below.
Deflect and hold the Joystick in the
full-left
position and then depress the Horn Button until there is a bleep, then release. The left-hand four speed LEDs will now flash as below.
Deflect and hold the Joystick in the
full-right
position and then depress the Horn Button until there is a bleep, then release. All five speed LEDs will now flash as below.
Deflect and hold the Joystick in the
full-reverse
position and then depress the Horn Button until there is a bleep, then release. All the speed LEDs will extinguish, but all ten battery gauge LEDs will flash as below to indicate the calibration sequence is complete.
Switch off the VSI.
Menu
Home
TAS
Mobility Accredited Partners and Centers
Servicing Instructions
VR2
Replacement of Keypad
Disassembly of the VR2 JSM
Replacement of Joystick Gaiter
Replacement of Joystick
Replacement of Cable Assembly
Reassembly of the VR2 JSM
VSI
Replacement of Keypad
Disassembly of the VSI
Replacement of Joystick Gaiter
Replacement of Joystick
Replacement of Cable Assembly
Reassembly of the VSI
Online Diagnostics
Printable PDF Diagnostic Guides
The Diagnostics Process
Other Conditions
Flash Code List
R-net Flash Codes
VSI Flash Codes
VR2 Flash Codes
Pilot+ Flash Codes
S-Drive Flash Codes
Egis Flash Codes
Solo
X25/X30 Flash Codes
Trio+
I-Drive
Trip Codes
R-net Trip Code Database
Industrial Controller Trip Code Database
Mobility Controller Trip Code Database
Application Support
Application Support Enquiry
FAQ's
Diagnostics Questions
Programming Questions
Services Questions
Product Questions
Training
Accredited Repairs Training
Site Map
We use cookies on this website, you can
read about them here
. To use the website as intended please...
ACCEPT COOKIES