Low Battery Voltage
The battery needs charging or there is a bad connection to the battery. Check the connections to the battery. If the connections are good, try charging the battery.
Motor Disconnected
The motor has a bad connection. Check all the connections and leads between the motor and the i-drive . Check the position of the freewheel switch.
Motor Wiring Trip
The motor has a short circuit to a battery. Check all the connections and leads between the motor and the battery.
Not Used
Not Used
Inhibit Active
The i-drive is being inhibited from driving
Throttle Trip
A throttle trip is indicated. Make sure that the throttle is in the rest position before switching on the vehicle.
Possible Control System Trip
A control system trip is indicated. Make sure that all connections are secure.
Solenoid Brake Trip
The parking brakes have a bad connection. Check the parking brake and motor connections. Make sure the control system connections are secure.
High Battery Voltage
An excessive voltage has been applied to the i-drive. This is usually caused by a poor battery connection. Check the battery connections.
Commonly Seen Informational Flash Codes
Control System in Sleep Mode
The control system has entered sleep mode. Switch the vehicle off and then on again.
Throttle Displaced
The throttle has been displaced while the vehicle is being switched on. Place the throttle in the neutral position and switch the vehicle off and on again.
If the problems persist after you have made the checks described above please contact your service agent.