VSI - Reassembly

  1. Ensure that the Joystick Cable is firmly connected at both ends – Joystick and ‘CON15’ on the PCB.
     
  2. Ensure the Gasket is correctly seated on the Base Casting.
     
  3. Align the Plastic Top to the Base Casting. Ensure that the Gasket is correctly positioned on both parts and that no internal wires have been trapped.
     
  4. Lightly tighten the front two screws, then the rear two screw and ensure both parts are still correctly aligned.
     
  5. Finally tighten all four screws. Do not over-tighten.
     
  6. Test all VSI functions are working correctly