Menu
Shopping Cart
Service Center
Home
/
Servicing Instructions
/
VR2
/
Disassembly of the VR2 JSM
Service Center
VR2 - Disassembly of the JSM
Using a
TORX10x70 driver
, remove the five Case Screws from the bottom of the VR2 JSM -
three in the front and two in the rear, as shown in the diagram below.
Carefully using a sideways pressure on the Plastic Top, separate the two halves of the VR2 JSM.
DO NOT
separate the halves by more than a few centimetres at this time, as they are internally connected via a wiring loom.
Disconnect the Cable Assembly from the PCB, as shown in the diagram below.
The two halves of the VR2 JSM can now be separated.
Identify whether the Joystick is a MAID type or a JC2000 type, refer to the photograph below.
If the Joystick is a JC2000, and you are not fitting a new Joystick Gaiter, remove the washer (as seen below) from within the existing Joystick Gaiter prior to fitting the new MAID Joystick.
Menu
Home
TAS
Mobility Accredited Partners and Centers
Servicing Instructions
VR2
Replacement of Keypad
Disassembly of the VR2 JSM
Replacement of Joystick Gaiter
Replacement of Joystick
Replacement of Cable Assembly
Reassembly of the VR2 JSM
VSI
Replacement of Keypad
Disassembly of the VSI
Replacement of Joystick Gaiter
Replacement of Joystick
Replacement of Cable Assembly
Reassembly of the VSI
Online Diagnostics
Printable PDF Diagnostic Guides
The Diagnostics Process
Other Conditions
Flash Code List
R-net Flash Codes
VSI Flash Codes
VR2 Flash Codes
Pilot+ Flash Codes
S-Drive Flash Codes
Egis Flash Codes
Solo
X25/X30 Flash Codes
Trio+
I-Drive
Trip Codes
R-net Trip Code Database
Industrial Controller Trip Code Database
Mobility Controller Trip Code Database
Application Support
Application Support Enquiry
FAQ's
Diagnostics Questions
Programming Questions
Services Questions
Product Questions
Training
Accredited Repairs Training
Site Map
We use cookies on this website, you can
read about them here
. To use the website as intended please...
ACCEPT COOKIES